Electrical engineering

admin

01.07.2022 - 16:52

How much current flows in a 1000-ohm resistor when 1.5 volts are impressed across it?

Question:

How much current flows in a 1000-ohm resistor when 1.5 volts are impressed across it?

Answers (1)

Jamie April 11, 2023 в 14:25

The current flowing in a 1000-ohm resistor when 1.5 volts are impressed across it can be calculated using Ohm's Law, which states that current is equal to voltage divided by resistance (I = V/R). So, in this case, the current would be: I = 1.5 V / 1000 ? I = 0.0015 A or 1.5 mA Therefore, the current flowing in a 1000-ohm resistor when 1.5 volts are impressed across it is 1.5 milliamps.

Do you know the answer?

Leave a comment Cancel Response

Not sure about the answer?

Find the right answer to the question How much current flows in a 1000-ohm resistor when 1.5 volts are impressed across it? by subject Electrical engineering, and if there is no answer or no one has given the right answer, then use the search and try to find the answer among similar questions.

Search for other answers

New questions in the category: Electrical engineering

A 22-kilo ohm resistor having a tolerance of 10% has failed. You have on hand five resistors, valued at 120, 220, 47, 33 and 120-kilo ohm, respectively. What combination of these would you choose to re

A 221 V battery, an inductor, and a 33 ohms resistor are connected in series, as shown in the diagram below. A two way switch makes it possible to include or exclude the battery. The switch that had been in position 1 long enough for the circuit to reach

A 10 micro F capacitor has been charged to a potential difference of 12 V. A 100 k ohm resistor is connected in series with the capacitor. What are the potential difference across the resistor, curren

What is the total resistance (RT) in the circuit? a. R1 = 7 ohms b. R2 = 10 ohms c. R3 = 6 ohms d. R4 = 4 ohms

A rechargeable flashlight battery is capable of delivering 90 mA for about 12 hours. How much charge can it release at that rate? If its terminal voltage is 1.5 V, how much energy can the battery deliver?

A 4.5V battery produces a current of 0.90A in a piece of copper wire. What is the resistance of the copper wire?

A 100 N force is applied to the side of a crate resting on a level floor. The crate has a mass of 50 kg. If the coefficient of static friction is s = .25, is the 100 N force enough to make the crate

The circuit breaker at a power seat motor continuously trips: Technician A says that this could be caused by a seat track problem that is causing mechanical resistance. Technician B says that this could be caused by corrosion at the motor, which is causin

Q. Large spool of copper wire is placed on 30 degree inclined plane. The loose end of the wire comes off of the top edge of the spool and is attached to a rigid pole at the top edge of the incline. Th

At the local playground, a 21-kg child sits on the right end of a horizontal teeter-totter, 1.8 m from the pivot point. On the left side of the pivot an adult pushes straight down on the teeter-totter

A 50.0-N box is sliding on a rough horizontal floor, and the only horizontal force acting on it is friction. You observe that at one instant the box is sliding the right at 1.75 m/s and that it stops in 2.25 s with constant acceleration. What magnitude fo

The average power dissipated in a 47 ohm resistor is 8.0 W. (a) What is the peak value i_0 of the ac current in the resistor?

A blow-dryer and a vacuum cleaner each operate with a voltage of 120 V. The current rating of the blow-dryer is 9 A, and that of the vacuum cleaner is 5.5 A. (a) Determine the power consumed by the blow-dryer. _____W (b) Determine the power consumed by

A rubber ball filled with air has a diameter of 25.0 cm and a mass of 0.540 kg. What force is required to hold the ball in equilibrium immediately below the surface of the water in a swimming pool?

A hand truck is used to move two kegs, each of a mass 56 kg. Assume g=9.8 m.s-2 and neglect the weight of the hand truck. ?=28 deg. 1- Determine in N the vertical force P that should be applied to the

(i) State Coulomb’s law and define the unit of charge. (ii) State and explain Ohm’s law.

What is a carbon film resistor used for?

Suppose that you have a 700-Ohm, a 790-Ohm, and a 1.20-kOhm resistor. What is the maximum resistance you can obtain by combining these? What is the minimum resistance you can obtain by combining these

3) A bug zapper consists of two metal plates connected to a high-voltage power supply. The voltage between the plates is set to give an electric field slightly less than 1*10^6 V/m. When a bug flies b

A component with a 17-ohm resistor is rated for use at power levels not exceeding 14 mathrm{W}. How much current can safely flow through the component?

Authorization

Password generation