17.07.2022 - 11:29

A GO/NO-GO plug gauge will be designed to inspect a 60.00 +/- 0.40 mm diameter hole. A wear allowance of 3% of the total tolerance band is applied to the GO side of the gauge. Determine the nominal sizes of the NO-GO gauge. (Round your answer to the neare

Question:

A GO/NO-GO plug gauge will be designed to inspect a 60.00 +/- 0.40 mm diameter hole. A wear allowance of 3% of the total tolerance band is applied to the GO side of the gauge. Determine the nominal sizes of the NO-GO gauge. (Round your answer to the nearest thousandth of an mm)

Answers (0)
  • Bernice
    April 18, 2023 в 00:05
    The total tolerance band for the GO/NO-GO plug gauge is 0.40 mm. Applying the wear allowance of 3% to the GO side, we have: Wear allowance = 0.03 x 0.40 = 0.012 mm The minimum acceptable size for the GO gauge is: 60.00 - 0.40 + 0.012 = 59.612 mm The maximum acceptable size for the GO gauge is: 60.00 - 0.40 = 59.600 mm For the NO-GO gauge, the size must be smaller than the minimum acceptable size for the GO gauge. We can make it 0.1 mm smaller, which gives us: 59.512 mm Therefore, the nominal sizes for the GO and NO-GO gauges are: GO gauge: 59.600 mm NO-GO gauge: 59.512 mm Note that we round our answer to the nearest thousandth of a millimeter.
Do you know the answer?

Leave a comment

Not sure about the answer?
Find the right answer to the question A GO/NO-GO plug gauge will be designed to inspect a 60.00 +/- 0.40 mm diameter hole. A wear allowance of 3% of the total tolerance band is applied to the GO side of the gauge. Determine the nominal sizes of the NO-GO gauge. (Round your answer to the neare by subject Math, and if there is no answer or no one has given the right answer, then use the search and try to find the answer among similar questions.
Search for other answers
New questions in the category: Math
Authorization
*
*

Password generation